Nicorette invisi step 2 15mg 7 patches

description

Details

Nicorette® invisi 15mg patch is used to relieve and/or prevent withdrawal symptoms and reduce the cravings you get when you try to stop smoking or when cutting down the number of cigarettes you smoke. It provides a safer alternative to smoking for both the individual and those around them.

Ideally you should aim to stop smoking. However Nicorette® invisi patch can be used in a number of different ways, either to completely replace all your cigarettes, or if do not feel ready to stop smoking completely, to replace certain cigarettes and therefore help you to cut down the number of cigarettes you smoke. It may also help increase your motivation to quit.

Directions

storage: Keep out of reach and sight of children. Do not store above 25°C. Dipose of sensibly. Please read the enclosed leaflet for instructions.

Directions: Use as part of the NICORETTE® invisi patch step down programme. For adults and children 12 years and over. Most smokers should start on 25 mg. Lighter smokers (less than 10 cigarettes per day are recommended to start on the lower dose 15mg. Apply the patch to a clean, dry area of skin in the morning and remove the patch 16 hours later. Please read the enclosed leaflet carefully before starting to use the product.

Warning: Do not exceed the stated dose

If you are pregnant or breast-feeding, talk to your doctor, pharmacist or nurse for advice before using this product.
If you need any advice before starting to use this product, talk to your doctor, pharmacist or a nurse.
Do not use if you are allergic to any of the ingredients listed below.

You are more likely to quit smoking when using this product with help from your pharmacist, doctor, a trained counsellor or a support programme.

Ingredients

This pack contains seven 13,5 cm2 transdermal patches, each containing nicotine 1.75 mg/cm2 (once-daily patch for application to the skin, releasing 15mg over 16 hours). Other ingredients are: Medium-chain triglycerides, basic butylated methacrylate copolymer, polyethlenterephthalate film (PET), acrylic adhesive solution, potassium hydroxide, croscarmellose sodium, aluminium acetylacetonate, siliconized PET release liner with aluminised single side, printing inks.

Reviews