Loose caps or crowns and lost fillings are fixed fast with Dentemp Custom's unique formula Provides instant pain relief Eat on it in 60 minutes Easy to use with dentures
Control the mix according to the easy directions and help get the best result available until you see your dentist.
To replace a lost filling: Wash hands. Rinse out cavity with warm water. Do not dry; leave moist. Use applicator to remove a small amount of Dentemp from vial, form into a ball with your fingers and press firmly into cavity. Scrape the material off your finger by scraping your finger along the edge of the tooth. Do not lift your finger straight up as this might loosen the material in the cavity. Bite down several times to ensure proper bite. REMOVE ANY EXCESS MATERIAL. RINSE OUT MOUTH WELL. Allow 2 hours to se before eating.
To re-cement loose caps or crowns: Wash hands. Prepare crown by carefully removing as much old cement as possible from inside the crown. Rinse well. Clean and rinse tooth area with water and leave moist. Fit crown back on the tooth before applying Dentemp. Make sure it fits properly. If you cannot do this, DO NOT PROCEED. See your dentist. Use applicator to removed a small amount of material from vial. Place a very small amount of Dentemp along the inside edge of the open end of the crown. Place crown on wet tooth and press firmly. Bite down several times to insure proper fit. If the bite is not completely comfortable. remove and repeat all steps until the crown feels normal. REMOVE AND EXCESS MATERIAL. RINSE OUT MOUTH WELL WITH WATER. Allow at least 2 hours to set before eating. Dentemp can be used to replace a bridge. Dentemp should not be used on implants or posts without dentist's advice.